Since 2003, ICS and President Clint Brown have been the preferred choice when constructing highly sensitive BSL-3 and 4 facilities using Arcoplast wall and ceiling systems. Between their extensive experience in working with Arcoplast gel coat panels and their acquired, hands-on knowledge and skill in meeting the rigorous construction demands of these facilities makes them the contractor of choice.

Description: A two-component, 2:1 mix, bright white, high-strength epoxy structural adhesive used to bond and seal Arcoplast fiberglass gel coated panels, fiberglass accessories, aluminum moldings, and metal trim. Bonds and seals with a highly impermeable, non-yellowing, high-gloss finish. It is environmentally neutral, with no odor after curing. However, a slight odor exists while curing.

The repair kit is conveniently and securely packed and shipped in a metal container and is available in quart or pint sizes.

PLEASE READ ALL INSTRUCTIONS BEFORE BEGINNING INSTALLATION.
These guidelines are given in good faith to help prevent installation problems caused by the most common errors.  Arcoplast, Inc. bears no responsibility for installation actions taken or not taken.  There are many nuances of installation not covered in these instructions that Arcoplast, Inc. assumes are general construction knowledge to an experienced installer.  Selection of an experienced wall liner installer is the sole responsibility of the project owner, if needed a certified applicator can be recommended.  These installation guidelines are strictly recommendations and are not intended to be a step-by-step, foolproof installation checklist.  Deviations from the guidelines are taken at the risk of the installer and owner.  If you have any questions about installation techniques for your particular project, please call 1-888-736-2726 or 636-978-7781.

Arcoplast sent a preassembled 4’ cube to have a vacuum decay test performed by Architectural Testing, Inc. The goal was to see what could be expected given an entirely sealed Arcoplast environment.

Arcoplast recently set out to determine the pressure loss possible when their fiberglass composite panels are secured using screws instead of an adhesive bond. They provided Technical Safety Services, Inc. with four 24”x24” 6mm cement core panels. A single, #12 stainless steel, pan-head, self-tapping screw was inserted into the center of each panel.